Filter
Top Products
Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
190-00592-06 Rev. A24
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
• XPDR
Displays transponder mode selection softkeys:
STBY
Selects standby mode (Transponder does not reply to any interrogations)
ON
Selects Mode A (Transponder replies to interrogations)
ALT
Selects Mode C – altitude reporting mode (Transponder replies to identification and altitude
interrogations)
GND
Manually selects Ground Mode (Transponder does not allow Mode A and Mode C
replies, but does permit acquisition squitter and replies to discretely addressed Mode S
interrogations)
VFR
Automatically enters the VFR code (1200 in U.S.A. only)
CODE
Displays transponder code selection softkeys 0-7
0 — 7
Use numbers to enter code
BKSP
Removes numbers entered, one at a time
• IDENT
Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
transponder return on the ATC screen
• TMR/REF
Displays/removes Timer/References Window
• NRST
Displays/removes Nearest Airports Window
• ALERTS
Displays/removes Alerts Window
Figure 1-19 XPDR Softkeys
INSET XPDR IDENT TMR/REF NRST ALERTSOBSPFD CDI
Press the CDI Softkey to cycle through
navigation sources:
- GPS
- NAV1 (VOR/LOC)
- NAV2 (VOR/LOC)
Press the BACK Softkey to
return to the top-level softkeys.
Press the IDENT or BACK
Softkey to return to the top-
level softkeys.
XPDR
STBY ON ALT VFR IDENT BACK ALERTSCODE
IDENT BACK
ALERTS
0 1 2 3 4 5 6 7 BKSP
GND
ADF/DME
(optional)
BACK
Press the OFF or BACK Softkey
to return to the top-level softkeys.
DCLTR
DCLTR-2
DCLTR-3
DCLTR-1
TOPO
ALERTS
NEXRAD
(optional)
TERRAIN
XM LTNG
(optional)
OFF
TRAFFIC
INSET
STRMSCP
(optional)
TRFC-2
TRFC-1
STD BARO
BACK
ALERTS
WIND
HSI FMT
PFD
Press the STD BARO or BACK
Softkey to return to the top-level
softkeys.
ALT UNIT
HPA BACK
ALERTS
METERS IN
DFLTS
Press the BRG1/BRG2
softkeys to display/remove
the Bearing Information
windows and cycle through
bearing sources:
- NAV1/NAV2
- GPS
- ADF
BACK
ALERTS
OPTN1 OPTN2 OPTN3
DME
(optional)
BACK
ALERTS
360 HSI
ARC HSI
BRG1
BRG2
OFF