Filter
Top Products
190-00592-06 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
115
AUDIO PANEL AND CNS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
ADF TUNING
ADF frequencies in the 190.0-kHz to 1799.5-kHz range are entered in the standby ADF frequency field of the
ADF/DME Tuning Window. The G1000 System does not tune the ADF emergency frequency, 2182.0-kHz.
Tuning an ADF frequency:
1) Press the ADF/DME Softkey to display the ADF/DME Tuning Window.
2) Turn the large
FMS
Knob to place the selection cursor over the standby ADF frequency field.
3) Turn the small
FMS
Knob to begin data entry and change each digit.
4) Turn the large
FMS
Knob to move the cursor to the next digit position.
5) Press the
ENT
Key to complete data entry for the standby frequency.
Figure 4-30 Entering ADF Standby Frequencies
Press the
ENT
Key to
Complete ADF
Frequency Entry
Turn the Small
FMS
Knob to
Enter Data in
the Standby ADF
Frequency Field
Turn the Large
FMS
Knob
to Move the
Cursor to the
Next Character
Pressing the
CLR
Key before completing frequency entry cancels the frequency change and reverts back to
the previously entered frequency.
Pressing the
CLR
Key when the cursor is flashing, clears the frequency and replaces the standby field with
0000.0.
Transferring the active and standby ADF frequencies:
1) Turn the large
FMS
Knob to place the selection cursor over the standby ADF frequency field.
2) Press the
ENT
Key to complete the frequency transfer.
Figure 4-31 Transferring ADF Frequencies
Press the
ENT
Key to Transfer
the ADF
Frequencies