Filter
Top Products
190-00592-06 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
117
AUDIO PANEL AND CNS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
DME TUNING
NOTE: When turning on the G1000 for use, the system remembers the last frequency used for DME tuning
and the NAV1
,
NAV2,
or
HOLD
state prior to shutdown.
The DME transceiver is tuned by selecting NAV1, NAV2, or HOLD in the ADF/DME Tuning Window.
Figure 4-34 ADF/DME Tuning Window, DME Modes
DME
Modes
The following DME transceiver pairing can be selected:
•NAV1 – Pairs the DME frequency from the selected NAV1 frequency.
•NAV2 – Pairs the DME frequency from the selected NAV2 frequency.
•HOLD – When in the HOLD position, the DME frequency remains paired with the last selected NAV
frequency.
Selecting DME transceiver pairing:
1) Press the ADF/DME Softkey to display the ADF/DME Tuning Window.
2) Turn the small
FMS
Knob to select the DME tuning mode.
3) Press the
ENT
Key to complete the selection.
Pressing the CLR Key or FMS Knob while in the process of DME pairing cancels the data entry and reverts
back to the previously selected DME tuning state. Pressing the FMS Knob activates/deactivates the cursor in
the ADF/DME Tuning Window.