Filter
Top Products
yellowblue
6-36
3. Remove the bulb socket
by turning it one
-quarter
of a turn
counterclockwise, while
pressing it firmly, then
pull it out. You can use
pliers to remove the bulb
socket if you are unable
to do it by hand.
4. Remove the wire connector from the bulb by lifting
the lock tab and pulling it away from the
plastic base.
5. Reverse the above steps to reassemble the
lamp assembly.
When reassembling the lamp, make sure to align the
pin at the outboard edge of the headlamp assembly
to the plastic retainer at the outboard edge of
the vehicle.