Filter
Top Products
91 | NAVISET ADMINISTRATOR 2 USER’S GUIDE
Creating Conditional Tasks
Conditional Tasks are created in the same way as other types of Tasks and are typically used to warn of abnormal
conditions in a device, or if a particular setting has changed. See the previous example for how to create a new task.
Select Conditional as the Task Type. Since this type of task is typically used to actively monitor a condition, the Polling
Interval and Total Run Time are enabled and specify how often the condition(s) should be checked while the task is
running.
The Polling Interval sets how often the devices are polled, and the Total Run Time species how long the task should
keep polling once the task has been started. If the task is to run continuously until it is stopped by the user, select No
Time Limit. Select Poll one time only if the task is to perform just one query and then stop.
!Note: Each task takes some time to complete, so care should be taken not to set a polling interval that is shorter than
the time it takes to poll all of the devices in the task. If a task is due to poll again before the previous poll has completed, a
warning message “Last Query Still Running” will be generated and the polling of all remaining devices will be skipped for
that polling interval.
Next select the Devices tab and select the devices that the Task will be performed on.