Filter
Top Products
86 | NAVISET ADMINISTRATOR 2 USER’S GUIDE
Display Schedule Tab
If one or more of the devices selected is an NEC display that supports internal scheduling (schedules that run
autonomously within the display), the Display Schedule tab will be shown.
The schedule settings can be optionally set for each of the 7 supported internal schedules to power the display on and
off, as well as setting different video inputs at specic times on specic days. When the task is run it will program the
selected displays with these schedule parameters. Once the displays have been programmed via the task, it is not
necessary to use NaViSet Administrator to perform the same schedule functions since the displays will perform them
automatically using the internal clock and scheduling feature.
!Note: The display’s internal clock can be synchronized to the current date and time by using the Command “Sync Clock
with System Date/Time” control listed in the Display Device Information category. This control allows the display’s
internal clock to be set with an oset value of from -23 to +23 hours, relative to the local time. This is useful if the display
being set is located in a dierent time zone. So for example to set the internal clock for a display that is located in a time zone
two hours ahead of the current local time, set the Oset hrs value to 2. All displays in this task will be set using the same
oset value, so displays across multiple time zones should be split into separate tasks.