Filter
Top Products
26 | NAVISET ADMINISTRATOR 2 USER’S GUIDE
Adding a single Windows computer on LAN (WMI)
Select Windows computer on LAN (WMI).
Enter the computer’s network name or IP address, or click Browse... to view and select a computer currently available
on the LAN.
!Note: It may take several seconds after clicking the Browse... button for the dialog to appear while the network is
enumerated. Only computers that are currently available on the LAN will be shown.
If you are currently logged in as a domain administrator and have credential access to the remote computer, then select
Connect as Current User.
If the remote computer requires different credentials, then either select Use Library Credential if the credentials required
have already been added to the Credential Library, or select Device-specic Credential to enter new credentials and
optionally save to the Credential Library. See page 74 for more information on using the Credential Library.
Click the Test button to conrm the network connection. If the connection is successful, then the computer’s name will
be automatically entered into the Device Name. The Device Name is the name used to identify the computer in the
device tree, and can be edited if desired before it is added to the device tree, or later on by renaming the device in the
device tree.
Click OK to add the Windows computer to the device tree. Any displays connected to the Windows computer will be
detected automatically and added to the device tree under the computer node.
Troubleshooting
If an error occurred when performing the Test operation see the troubleshooting steps “Problem: Unable to connect to
a Windows Computer via WMI” on page 135.