Filter
Top Products
5-17
Rev 1
8.If instead, you wish to create a waypoint at a position
that you specify, position the cursor over USER
POS?and press E. A page with the identifier at
the top and dashes at the bottom will now be dis-
played (figure 5-56). The cursor will be over the
dashed latitude field. The latitude and longitude of
the waypoint must be entered. To do so, turn the
right inner knob to display an N(for North) or an S
(for South). Next, select the latitude in degrees, min-
utes, and hundreths of a minute by using the right
outer knob to position the cursor and the right inner
knob to select the desired numbers (figure 5-57).
When the complete latitude has been selected,
press E. The cursor will jump down to the longi-
tude field. Turn the right inner knob to select W(for
West) or E(for East). Use the right outer and inner
knobs to select the longitude. Press Eto approve
the waypoint position (figure 5-58).
9.Turn the right inner knob one step clockwise to dis-
play the APT 2 page (figure 5-59). To enter an air-
port elevation press the right Cand rotate the right
outer knob to position the cursor over the dashes to
the right of ELV. Use the right outer knob to position
the cursor until the entire elevation is selected.
Press Eto store. Press the right Cto turn off
the right cursor function (figure 5-60).
10.Turn the right inner knob one step clockwise to dis-
play the APT 3 page (figure 5-61). To enter a run-
way length, press the right Cand rotate the right
outer knob to position the cursor over the five
dashes directly beneath RWY LEN. Use the right
inner knob to select each individual digit and the
right outer knob to position the cursor until the entire
runway length is selected. Press Eto approve the
runway length. The cursor will move to the surface
position. Turn the right inner knob to select either
HRD(for hard surface) or SFT(for soft surface).
Press Eto approve the runway surface. Press the
right Cto turn off the right cursor function (figure
5-62).
11.Airport remarks may be stored on the APT 5 page
using the procedure described in section 3.11.6,
“The Airport 5 Page (APT 5)”.
Figure 5-56
| FARM
|
|
|
|! !!^!!.!!'
|!!!!^!!.!!'
CRSR
Figure 5-57
| FARM
|
|
|
|N 39^32.73'
|!!!!^!!.!!'
CRSR
Figure 5-58
| FARM
|
|
|
|N 39^32.73'
|W 96^40.18'
APT 1
Figure 5-59
| FARM
|
|
|ELV !!!!!ft
|
|
APT 2
Figure 5-60
| FARM
|
|
|ELV 01250ft
|
|
APT 2
Figure 5-61
| FARM
|
|RWY LEN
| !!!!!' !!!
|
|
APT 3
Figure 5-62
| FARM
|
|RWY LEN
| 02300' SFT
|
|
APT 3