Filter
Top Products
Page 76
Modem Interface
Section 4
4.8 Modem Interface
4.8.1 Programming the Modem
1. From the Main Menu, select OPTIONS > ADVANCED OPTIONS >
COMMUNICATIONS SETUP > MODEM POWER.
2. To enable the modem power, press the CHANGE CHOICE key until
“ENABLED” shows up in the center of the display. Press the
ACCEPT soft
key to continue.
3. Set the dial method, Tone or Pulse using the
CHANGE CHOICE soft key.
Press the
ACCEPT soft key to continue.
4. Enter the phone number of the PC that the unit will call if alarms
are enabled, using the numeric keypad. Press the
ACCEPT soft key
to continue.
5. Enable or Disable the Pager Option using the
CHANGE CHOICE soft key.
Press the
ACCEPT key to continue.
6. Enter the Pager Service Number using the numeric keypad. Press
ACCEPT to continue.
7. Enter the amount of pagers. Press
ACCEPT to continue.
8. Enter up to three pager numbers. Press
ACCEPT to continue.
9. Set the Reporting Order (Modem only, pager only, pager then modem,
modem then pager), using the
CHANGE CHOICE soft key.
10. Press the
ACCEPT soft key to finish.
Modem power must be enabled and the unit must be in running mode before
the meter can answer calls from InSight, InSight® Gold, or VISION software
to download data, access remote program, etc.
11:00 AM 21 - APR - 01 MODEM SETUP
ACCEPT MODEM POWER:
CHANGE
CHOICE
ENABLED
RETURN
CHOICES: ENABLED, DISABLED