Filter
Top Products
Page 129
Programming Worksheet
Appendix D Programming Worksheet
Basic Programming Guidelines
• Go through all items in the Setup menu and configure each one to your
requirements.
• Next, review the items in the Advanced Options menu and configure any
items you need.
• Always check Data Logging and Totalizer Setup. Data logging channels
must be enabled if you want to record the data in memory. Also, the
totalizer should be configured with an acceptable scaling factor for the
flow rate at each site.
• Go to the options menu and set the time and date if they have not already
been set.
• When finished, press the
RUN/STOP key to start the program.
• Photocopy the following worksheets to record your program settings at
each site for easy reference.
SETUP MENU
From the Main Menu, select
SETUP, MODIFY ALL ITEMS.
1. Select FLOW unit of measure (gps, gpm, gph, lps, lpm, lph, mgd, afd, cfs,
cfm, cfh, cfd, cms, cmm, cmh, cmd): __________
2. Select LEVEL unit of measure (cm, m, in., ft): __________
3. Select a PRIMARY DEVICE:___________
Flume: Type______________, Size__________________
Weir: Type______________, Size__________________
Nozzle: Type______________, Size__________________
Manning Formula:
Slope________, Roughness___________, Pipe Diameter___________
Power Equation:
K
1
=_________, n
1
=_________, K
2
=_________, n
3
=_________
Head vs. Flow
4. Enable PROGRAM LOCK password: (Y / N)
(Password is always 9800)
5. Enable SAMPLER PACING: (Y / N):
Flow interval:__________, Flow unit of measure:___________
Name: Date: Serial No.: ID No.:
Program Software Versions for:
Flow Meter: DTU: InSight
®
Gold InSight Vision StreamLog