Filter
Top Products
Page 74
Rain Gauge
Section 4
4.4.1.2 Set Point Alarms
Set Point Alarms activate when a user-definable high and/or low set point
is reached.
1. Select an action to occur when the alarm is activated.
2. Enable one of the alarm conditions.
3. Set either a High trip point or a Low trip point.
4. After entering the trip point enter the deadband value. The deadband is
the area between the alarm “turn on” and “turn off”. Refer to section on
page 121.
Set Point Alarm Conditions:
4.5 Rain Gauge
4.5.1 Programming the Rain Gauge
1. From the Main Menu Select OPTIONS>ADVANCED OPTIONS>DATALOG.
2. Highlight SELECT INPUTS using the up and down arrow soft keys and then
press the
SELECT soft key.
Note: If logging is enabled on any
channel, that channel will have an
arrow in front of the channel name
to signify that the channel is logged.
3. Highlight Rainfall using the up and down arrow soft keys, then press the
SELECT soft key.
4. Press the
CHANGE CHOICE soft key to cycle between “Logged” and “Not
Logged”, then press the
ACCEPT soft key.
5. Enter a logging interval using the numeric keypad, then press the
ACCEPT
soft key. Valid logging intervals are shown on the status bar along the
bottom edge of the display.
6. Select Rainfall Units (in. or cm). Press the
ACCEPT soft key to continue.
7. Select another channel to configure, press the RETURN soft key to
back up one step, or press the
MAIN MENU function key to return to the
Main Menu.
• Level • Flow
• Flow Rate of Change • pH
• Rainfall • Analog Channels 1–7
• Temperature • Velocity