Filter
Top Products
Section 2
Page 55
Wiring the Submerged Area Velocity Sensor
Figure 27 Junction Box, Probe, Cable Connection, and Desiccant Canister
2.19.2 Submerged Area Velocity Sensor Cable Quick-Connect
The quick-connect hub allows easy installation and removal of the submerged
area velocity sensor. Connect the submerged area velocity sensor cable to
the quick-connect hub:
1. Remove the rubber cap on the quick-connect hub. See Figure 25.
2. Place the connector-end of the cable to the quick-connect hub and tighten
the connection by turning the cable connector securement ring clockwise.
2.19.2.1 Desiccant Cartridge
Make sure vinyl tubing is securely fastened at both fittings (Figure 27). Failure
to do so will allow fluid or moisture to pass down or block the pressure
transducers reference port. This will result in faulty readings and could lead to
sensor failure.
During installation, arrange the sensor so that the desiccant cartridge hangs
down as shown in the Figure 27.