Filter
Top Products
Page 59
Basic Programming Setup
Section 3 Basic Programming Setup
3.1 Initial Power-Up of Meter
After power is applied, the flow meter performs a complete diagnostic self-test
and displays the menu shown when the unit was last turned off. Set the
instrument programming features when the Main Menu is displayed. The Main
Menu is the starting point for all programming operations. The Main Menu
offers four choices:
• Setup—Basic programming
• Status—Lists all currently measured readings
• Display Data—Shows graphs and tables of logged data
(See Displaying Data on page 117)
• Options—Advanced programming
Setup and Options functions lead to sub-menus and will configure the basic
and advanced features of the flow meter. Refer to the Main Program Flow
Chart on page 149. The Display Data and Status lead to sub-menus and will
provide information only. Press the
STATUS soft key to display any data
channels that have enabled logging (flow, pH, temp., etc.).
3.2 Basic Programming
Note: To make changes to the
program entries after the basic
programming setup, press the
MAIN MENU key and select
SETUP>MODIFY SELECTED
ITEMS. Highlight the program
entry using the up and down arrow
soft keys.
Basic programming setup must be performed, in its entirety, after the
instrument is installed. Refer to the 980 Flow Meter Basic Programming Setup
Flow Chart on page 150 for more information. The basic program setup will
modify all items:
Step 1 - Setup
1-A. Press the SETUP soft key from the Main Menu to prepare the 980 Flow
Meter for use.
1-B. Press the
MODIFY ALL ITEMS soft key and press the ACCEPT soft key to
begin setting up the flow units.
11:00 AM 21 - APR - 01 * Main Menu*
DISPLAY DATA SETUP
OPTIONS STATUS
READY TO START
• Flow Units • Site ID
• Primary Devices • Velocity Direction
• Program Lock • Velocity Units
• Sampler Pacing • Velocity Cutoff/Velocity Default