Filter
Top Products
Page 72
Mechanical Totalizer
Section 4
3. Set the Totalizer Scaling factor using the CHANGE CHOICE soft key. All
three totalizers are scaled with one of seven scaling factors: X1, X10,
X100, X1000, X10,000, X100,000 or X1,000,000. The selected scaling
factor always applies to all totalizers. Press the
CHANGE CHOICE soft key
to cycle through the available scaling choices.
4. Press the
ACCEPT soft key to continue.
5. Set the Total Flow Units using the CHANGE CHOICE soft key to cycle
through the choices. Total Flow Units are independent of the flow units
selected in the Setup Menu. Flow units of measure include:
6. Press the
ACCEPT soft key to continue.
4.3.1.2 Reset (Totalizer)
Note: The mechanical totalizer
cannot be reset manually.
The non-resettable totalizer will only be reset if one of the following
conditions occur:
Note: If any type of condition
occurs, both the resettable and the
non-resettable totalizers are reset.
The resettable totalizer can be used
to total flow over a finite period and
can be reset as often as desired
without affecting the other totalizers.
1. Select RESET from the TOTALIZER menu. A confirmation message
will appear.
2. Press the
YES soft key to reset the totalizer or press the NO soft key to not
reset the totalizer.
To reset both software totalizers at once, start a program with the
RUN/STOP key.
View Totals
To view the current totals of both the resettable and non-resettable totalizers,
press
VIEW TOTALS from the Totalizer menu. Both totalizer values will appear.
• Acre-feet • Liters • Gallons
• Cubic Feet • Cubic Meters
• Change in totalizer scaling • Change in primary device
• Change in totalizer units of
measure
• Start of new program