Filter
Top Products
Appendix D
Page 131
Programming Worksheet
3. Calibrate inputs (as needed): __________chk
4. Communications Setup: (If modem is enabled) ACCEPT any baud rate
displayed. [Modem will independently establish actual baud rate between
1200 and 14,400.]
Pager Phone Numbers (if enabled): Pager Service:_____________
Pager #1: ___________ Pager #2: ___________ Pager #3: ___________
Select Baud Rate for RS232 (1200, 2400, 4800, 9600, 19200):_________
5. Configure DATA LOGGING for each desired channel:
6. Configure Flow Totalizer:
Scaling: _________________ (X, X1, X10, X100.... X1,000,000)
Flow Units (Acre-feet, cubic feet, gallons, liters, cubic meters):_________
7. Configure SETPOINT SAMPLING if it is desired to trigger a sampler
based on one of the following conditions:
Channel Name Analog Channel Signal Description Logged (Y/N) Units Logging Interval (min)
Process Temperature
Rainfall
pH
Level / Flow
Analog Channel 1
Analog Channel 2
Analog Channel 3
Analog Channel 4
Analog Channel 5
Analog Channel 6
Analog Channel 7
Channel Name High Trigger Low Trigger Deadband Time Interval
Level
Flow
Flow Rate of Change
pH