Filter
Top Products
32 C-Series Display Reference Manual
3.4 Navigating to a waypoint
This section explains how to start and stop navigating to a waypoint. When you
navigate to a waypoint or to the cursor position, the data is sent on NMEA 0183 and
SeaTalk and can be used by an autopilot, if connected. For more information on
navigation, see
page 56
.
Start navigating to a waypoint
You can navigate to a waypoint using the cursor, via the
WPTS MOB button or by selecting the GOTO option.
Once navigation is active, the waypoint symbol is
surrounded by a box and a dashed line appears between
your boat and the waypoint.
If required you can display navigation details for the
active waypoint in the data bar (see
page 180
).
...using the cursor
To navigate to a waypoint using the cursor, when a chart or radar application is active:
...via the WPTS MOB button
To navigate to a waypoint using the WPTS/MOB button when any application is active:
.... by selecting the GOTO option
You can navigate to a waypoint using the GOTO option when a chart application is
active and the top level chart soft keys are displayed:
D8285_1
GO TO WAYPOINT
D7461_4
WPT
Position cursor over
waypoint to go to.
D6559-3
WPTS/
MOB
GOTO WAYPOINT
OPTIONS ...
GOTO WAYPOINT
Select required waypoint
Waypoint List
GO TO ...
D
7
5
0
3_
2
Select required waypoint
GOTO WAYPOINT
Or
GOTO CURSOR
GOTO WAYPOINT
OPTIONS...
Waypoint List
81221_4.book Page 32 Tuesday, February 28, 2006 5:24 PM