Raymarine C Series GPS Receiver User Manual


 
Chapter 2: General Operation 5
Chapter 2: General Operation
2.1 Introduction
This chapter gives details of the general operation of the C-Series display, and covers
the following subjects:
Powering the display on/off.
Using the controls.
Application display.
Displaying and editing additional information.
Adjusting the display lighting.
Initial setup procedures.
Using CompactFlash cards.
Managing data.
Emergencies and warnings.
2.2 Powering the display ON/OFF
Power ON
Press the POWER button until the introductory logo is displayed. The keys
light up and after a few seconds an application page and a navigation
warning is displayed. Read this information and then press OK to remove it.
At this time the radar scanner (if fitted and powered) is checked for compatibility with
the display. An error message is displayed if the scanner is incompatible.
Power OFF
Press and hold the POWER button until the power down count reaches
zero. If the POWER button is released within the countdown period, power
off is cancelled.
Remember to replace the suncover to protect the display.
D6577-1
81221_4.book Page 5 Tuesday, February 28, 2006 5:24 PM