Filter
Top Products
Chapter 6: Using the Radar 149
Function
Description
Options
(Default in bold)
Interference Rejection
When ON, any mutual radar interference between two radar equipped
vessels operating within range of each other, is automatically reduced.
NORMAL
HIGH
Target Expansion
When ON, targets are magnified to make them easier to see.
LOW
HIGH
Wakes Period
When ON, the target is displayed at the brightest level and its previous
positions are retained at successively fainter levels on the screen.
10 seconds
30 seconds
1 minute
5 minutes
10 minutes
Timed Transmit
Controls the radar’s timed transmission power-save mode.
OFF
ON
Transmit Period
When ON, the scanner performs the number of scans specified and then
shuts down for the number of minutes specified by the Standby Period.
10 scans
20 scans
30 scans
Standby Period
Indicates the number of minutes that the system shuts down - the scan-
ner does not rotate and the display is in standby mode.
3 minutes
5 minutes
10 minutes
15 minutes
Sea Clutter Curve...
Adjusts the acuteness of the sea clutter curve when the sea clutter
option is set to manual (see
page 122
).
1-8
Antenna Size
If an open array scanner is fitted, this specifies the size of the scanner.
Open array
48”
72”
Bearing alignment
Correct for display azimuth error.
Please refer to the C-Series installation guide.
Radar Advanced Setup
Please refer to the C-Series installation guide.
D8437_1
MENU
Highlight Radar
Setup menu
Enter Radar Setup
menu
Radar Setup Menu
Active Scanner 2kw Radome
Interference Reject NORMAL
Target Expansion LOW
Wakes Period 1min
Timed Transmit OFF
Transmit Period 10 SCANS
Standby Period 3 MINS
Sea Clutter Curve...
Antenna Size Radome
Bearing Alignment
Radar Advanced Setup...
Setup
Radar Setup...
GPS Status...
Compass Setup...
System Setup...
81221_4.book Page 149 Tuesday, February 28, 2006 5:24 PM