Raymarine C Series GPS Receiver User Manual


 
Chapter 13: Maintenance & Troubleshooting 195
Settings and data reset
All data set-up menus, including page sets and the data bar, are reset to the factory
default when you apply a settings and data reset.
Important: Applying a settings and data reset will remove all waypoints, routes and
tracks.
Applying a settings and data reset
To carry out a settings and data reset:
The system resets and returns you to the power on procedure.
13.4 Troubleshooting your Display
All Raymarine products are, prior to packing and shipping, subjected to
comprehensive test and quality assurance programs. However, if your C-Series Display
unit should develop a fault, this section will help you to identify the most likely cause
and show the corrective action required to restore normal operation.
If, after referring to this section, you are still having problems with your Display, contact
your local dealer, national distributor or Raymarine Technical Services Department for
further advice.
Always quote the product serial numbers which are printed on the back of the unit.
Common problems and how to solve them
This section is divided into problems associated with:
Installation/Display.
Chart application.
Fishfinder application.
Radar application.
D8663_1
MENU
Highlight System
Setup menu
Select System
Setup menu
Position mode...
ID Setup...
Simulator...
Bearing Mode...
MOB Data Type...
Manual Variation...
Language...
Extendeded Charater Set...
Ground Trip Reset
Settings Reset
Lat/Long
ON
True
Position
Auto (01
o
E)
00
o
English (US)
OFF
System Setup Menu
Settin
g
s an
d
Data Rese
t
Highlight settings
and data reset
Select settings
and data reset
Yes
Setup
Radar Setup...
GPS Status...
Compass Setup...
S
ystem
S
etup..
.
81221_4.book Page 195 Tuesday, February 28, 2006 5:24 PM