Filter
Top Products
176 C-Series Display Reference Manual
11.8Simulator
We recommend that you use the simulator to familiarize yourself with the AIS function.
When the system simulator is switched on (see
page 184
), it displays 20 AIS targets
within a 25nm range. These targets are displayed using the appropriate AIS targets
status symbol (see
page 170
) and move around the screen as if they were real targets.
Important: Incoming safety messages cannot be displayed while the simulator is
switched on.
11.9AIS Layer Setup Menu
The AIS Layer Setup Menu allows you to:
• Select the target types displayed (ALL or DANGEROUS).
• Switch the dangerous and lost target alarm warning ON/OFF.
• Switch the display of AIS safety messages ON/OFF.
• View the list of active AIS unit alarms.
To display the AIS Layer Setup Menu:
1. Set the AIS LAYER status to ON ((see
page 169
).
2. Select the AIS Layer Setup:
D8969_1
AIS Layer Setup
AIS Alarms List...
D
isplayed Tar
g
et Type
s
All
Setup
Chart Setup...
Cartography Setup...
GPS Status...
Compass Setup...
AIS Layer Setup
Highlight AIS
Layer Setup
Select AIS
LayerSetup
MENU
Highlight required
option
Select option
Set/view as required
81221_4.book Page 176 Tuesday, February 28, 2006 5:24 PM