Raymarine C Series GPS Receiver User Manual


 
110 C-Series Display Reference Manual
5.7 Fishfinder alarms
In addition to the system alarms (see
page 187
), the following alarms can be set when
you are connected to a DSM or when the simulator is on:
Fish Alarms - sound when a target meets the specified sensitivity level and, is
within the depth limits (if enabled). The greater the fish alarm sensitivity, the
greater the number of target image depths displayed.
Shallow/Deep Alarms - sound when the DSM detects that the depth is less than
the shallow limit, or greater than the deep limit.
You can switch the alarms on, set the limits and specify the fish alarm sensitivity as
described on
page 188
.
5.8 Setting up your fishfinder
The set up for your fishfinder can be changed from the standard configuration to suit
your particular needs. The Fishfinder Setup Menu is divided into three sections:
Display settings.
Transducer settings.
DSM settings.
To select the Fishfinder Setup Menus:
Note:
For general information on the Setup Menus, see page 183.
D8456_1
MENU
Setup
GPS Setup...
Compass Setup...
Enter Fishfinder
Setup menu
Select required function
Fishfinder Setup Menu
Depth Digit Size LARGE
Depth Digit Position BOTTOM
Target Depth ID OFF
Depth Lines OFF
Color Palette Copper
Scroll MANUAL
Manual Scroll Speed 100%
Select Transducer P65/P66
Select Speed Transducer UNKNOWN
Depth Offset (Waterline) 0.0ft
Depth Offset 100%
Temperature Offset 0.0
0
F
Frequency Calibration...
DSM Reset...
Trip Counter Reset...
SONAR interference Rejection Auto
2nd Echo Interference Rejection OFF
Ping Rate Limite (per sec.) 30
Ping Enable
F
ishfinder Setup..
.
Display
settings
Transducer
settings
DSM
settings
81221_4.book Page 110 Tuesday, February 28, 2006 5:24 PM