Filter
Top Products
Chapter 9: Using the Engine Monitor 161
9.3 The engine monitor display
Engine data is displayed in a series of pre-configured panels. Each panel contains a
particular set or data. You can choose the panel that suits your requirements via the
soft keys:
9.4 Configuring the engine panels.
You can configure each panel by changing the size and number of data cells and the
data contained in each cell. You can also rename each panel. For further detail, please
refer to
page 153
.
Note: Configuring engine panels is a local setting and will therefore only affect
the individual display on which you are working.
9.5 What should I do when an alarm is triggered?
Your engine monitor application will trigger an alarm (via NMEA/SeaTalk
2
) and display
an engine alarm warning message when a problem is detected. When this occurs, you
should check your engine monitoring system and if necessary refer to the
documentation supplied with your engine system. Press ACKNOWLEDGE to silence
the alarm.
Note: When engine monitoring is active, all other system alarms continue to trig-
ger.
Panel Type
D9105_1
Data content
Tacho &
engine hours
Oil pressure
Engine coolant
temperature
Boost
pressure
Alternator
Fuel level
(tanks 1 & 2)
Fuel rate
Total fuel
Engine
Engine
& fuel
Fuel
resources
Engine &
resources
Twin
engines
81221_4.book Page 161 Tuesday, February 28, 2006 5:24 PM