Filter
Top Products
ENGINE
3.43
balance shaft gear.
2871043
23. Inspect the crankshaft gear (Q) for broken orworn
teeth. If the crankshaft gear does not need to
be replaced, it does not need to be removed.If
the crankshaft gear is damaged, remove the
crankshaft gear with the Flywheel Puller (PN
2871043).
Q
24. Install the two puller bolts (R). Tighten the puller
bolts up so that the bolts are at equal length.
R
25. Install the Flywheel Puller (PN 2871043) and
remove the crankshaft gear, if needed.
2871043
Water/Oil Pump Removal/Disassembly
26. Rotate the water/oil pump gear (S), sothat allfour
bolts are visible though the gear. Remove thefour
bolts with a hex wrench. Pull out the pump.
S
27. Inspect the oil pump rotors for wear. Mark the
rotors with a white pen to ensure upon
reassembly that the correct sides of the rotors are
installed and mesh with the same edges as
previously installed.
Mark Rotors
NOTE: If replacing the old rotors, new replacement
rotors will fit into the old oil/water pump housing.