Filter
Top Products
ENGINE
3.53
PU--45498
27. Reinstall the camshaft gear; so the timing marks
are properly aligned. Install the washer and bolt.
Torque to 22 ± 2 ft. lbs.(30 ± 3 Nm).
NOTE: Be sure all of the timing marks are properly
aligned.
Timing Marks
K
M
N
Water Pump Gear
Timing Marks
Timing Marks
Counterbalance Gear and Camshaft
Gear Bolt Torque:
22 ± 2 ft. lbs. (30 ± 3Nm)
GEAR/STATOR HOUSING SEAL REPLACEMENT
IMPORTANT: Due to seal design and
construction, these seals MUST be installed dry
(no lubricant) during assembly. Use of lubricants
(oil, soapy water, etc.) will not allow the seal to
wear--in and seal properly. Do not touch seal
surface or allow seal surface to come in contact
with contaminates during installation.
Thoroughly clean parts, tools and hands before
installation.
28. Before installing the gear/stator housing, replace
the seals in the cover. Install a new water pump
seal (N) into the gear/stator housing (O). Use the
Water Pump Mechanical Seal Installer
(PA--44995) to properly install the seal to the
correct depth in the cover.