Filter
Top Products
ELECTRICAL
10.31
HIGH BEAM HEADLIGHT
ADJUSTMENT
The headlight beam can be adjusted to any position
desired by turning the adjusting knob located on the
bottom right side of the headlight pod.
Raise Headlight -- Turn knob counter-- counterclockwise
Lower Headlight -- Turn knob clockwise
Headlight Adjustment Knob
1. Place the vehicle on a level surface with the
headlight approximately 25’ (7.6 m) from a wall.
25’ (7.6 m)
Lamp Center Height
2″ (5.1 cm)
2. Measure the distance from the floor to the center
of the headlight and make a mark on the wall at
the same height.
3. Start the engine and turn the headlight switch to
high beam.
4. Observe headlight aim. The most intense part of
the headlight beam should be aimed 2″ (5.1 cm)
below the mark placed on the wall in Step 2
NOTE: Rider weight must be included on the
seat. On machines with separate low beam
lights, the drop should be 8″ (20.3 cm) in 25’ from
the center of the low beam lamp.
5. Adjust beam to desired position .
LOWER HEADLAMP
REMOVAL/INSTALLA
TION
Loosen Tighten
Turn Harness Assembly
1. Turn the back of the headllamp harness in a
counter--clockwise direction to loosen.
2. Pull the harness assembly out from the headlight
assembly.
3. Remove the lamp and replace with a new
headlamp.
NOTE: Do not touch the new lamp with bare fingers.
Hold the plastic part (1) of the lamp. Oil from your skin
leaves a residue, causing a hot spot that will shorten
the life of the lamp.
1
4. Install the harness assembly into the headlight
assembly. Turn the headlight harness clockwise
to secure the headlamp into place.