Filter
Top Products
ENGINE
3.58
45. After the engine is completely assembled and
ready for installation, the engine must be properly
primed with Polaris 0W--40 Synthetic Oil (PN
2871281). Fill the oil filter three--quarters full with
Polaris 0W--40 Synthetic Oil (PN 2871281). Let
the oil soak into the filter for 8--10 minutes. Install
the filter onto the engine.
Fill 3/4 full with 0W--40 oil
46. Remove primer plug from the engine. Install the
Oil System Priming Adapter (PU--45778) into the
oil plug hole. Push 3--5 oz. (approx.) of Polaris
0W--40 into the adapter until resistance is felt.
Remove the adapter. Apply pipe dope or Teflon
tape to the plug threads. Install the plug and
torque to 216 ± 24 in.lbs. (24.4 ± 2.71 Nm).
PU--45778
Oil System Priming Adapter:
(PU--45778)
WARNING: After any reassembly or
rebuild, the engine must be primed using
the Oil Priming Adapter (PU--45778) and
a 3/4--full oil filter before initial start--up.
Follow the steps in this section to
properly prime the engine and aid proper
engine break in. Failure to perform this
procedure may cause internal engine
damage on initial start--up.