Filter
Top Products
FINAL DRIVE
7.23
REAR DRIVE SHAFT
INSTALLA
TION
1. Slide shaft assembly into bearing carrier hub.
2. Apply anti-seize compound to splines of shaft.
3. Install a new lock ring and install the shaft.
4. Lift bearing carrier into place and install bolt to
upper control arm. Torque bolt to 35 ft. lbs. (48
Nm).
5. Install hub, flat washer, domed washer (domed
side out) and nut. Torque center hub nut to 80 ft.
lbs. (109 Nm). Install new cotter pin and hub cap.
Rear Hub Nut Torque:
80 ft. lbs. (109 Nm)
6. Install rear wheel and torque wheel nuts to
specification.
Out
Cone
Washer
Cone
washer
dome to
outside
80 ft. lbs.
(109 Nm)
Flat Washer
Rear Wheel Nut Torque:
Refer to Page 7.2
7. Grease all fittings thoroughly with Premium
U-Joint Lubricant (PN 2871551).