Filter
Top Products
FINAL DRIVE
7.24
REAR DRIVE SHAFT
SER
VICE
1. Removeclamps from rubber boot(s) using the CV
Boot Clamp Pliers (PN 8700226)(A).
A
2. NOTE: Photo below is shown without shaft for
clarity. Wipe grease away from recess in CV joint
inner hub to locate snap ring.
Snap ring located in
recessed area
Snap ring
3. Open the snap ring using a snap ring pliers or
small needle nose pliers. Tap CV housing off
shaft with a soft faced hammer while holdingsnap
ring open.
Tap CV Housing
Off Shaft
Spread ends of snap ring
to remove joint from shaft
4. Placea newsnap ring in the groove of the CV joint
inner hub, with tabs facing the shaft as shown.
Tabs face shaft