Filter
Top Products
ENGINE
3.41
Inspect Teeth & Tabs
Replace Three Springs
Cam Gear Reassembly
15. Install the new springs into the grooves of thecam
gear.
Insert Springs
16. Insert the pointed dowels from the Tapered Pins
(PU--45497--1) into the cam gear.
PU--45497--1
To assemble:
S Hold the spring with one finger.
S Start the pointed end of the tapered
pin into the cam gear hole and slowly
push the dowel through the hole until
the end of the dowel is almost flush
with the spring.
S Perform this procedure with all three
tapered pins.
S Do not push the pins too far
through or the springswill pop out.
NOTE: Do not remove the tapered pins at this time.
17. Note in the photograph that the Tapered Pins
(PU--45497--1) are below flush with end of the
springs. This helps to align the three gear tabs
during the next step.
PU--45497--1