Filter
Top Products
ENGINE
3.56
(PA--45401)
(PA--45658)
O
Gear/Stator Housing Bolt Torque:
96 ± 12 in. lbs. (10.85 ± 0.35 Nm)
*Torque in Proper Sequence (Pg. 3.3)
NOTE: Before assembly, clean the bolts and bolt
holes with Primer N (PN 2870585) to remove any
debris. This will ensure proper sealing when installing
bolts.
37. Install shaft seal with ceramic surface facing
inward.
38. Install water pump impeller (P). Secure the
impeller with the washer and a new nylok
nut
(Q)
. Torque the nut to specification.
P
Q
Water Pump Impeller Nut Torque:
108 ± 12in.lbs.(6.8± 0.68 Nm)
39. Install water pump cover (R) with new O-ring seal.
Torque bolts to specification in proper sequence
(See Pg. 3.4).
R
Install Dry
Do not use lubricants or
sealants on O--ring Seal
96 ± 12 in. lbs. (10.85-1.35 Nm)
Water Pump Housing Bolt Torque:
96 ± 12 in. lbs. (10.85-1.35 Nm)
*Torque Bolts in Proper Sequence (Pg. 3.4)