Filter
Top Products
ENGINE
3.55
(PA--45658)
32. Before installing the gear/stator housing cover,
install the Water Pump Seal Saver (PA--45401)
onto the water pump shaft.
PA--45401
33. Install the new gasket to the gear/stator housing
cover and crankcase. With the tools installed,
carefully place the gear/stator housing cover over
the protection tools. NOTE: New gasket is not
shown in the picture.
34. Apply Crankcase Sealant (PN 2871557)tothe
outside edges of the crankcase halves (See
arrows), where the crankcases mate. (See
photos below.) This helps to prevent coolant
leakage.
35. Install the gear/stator housing gasket onto he
crankcase.
Gear/Stator
Housing Gasket
36. Secure the gear/stator housing cover (O) to the
crankcase with the cover bolts. Torque bolts to 96
± 12 in.lbs. (10.85 ± 0.35 Nm) in proper tightening
sequence (see Pg. 3.3). Remove seal protectors
from the shaft ends once secure.