Filter
Top Products
ELECTRICAL
10.32
Lower Headlamp Housing Removal
(if required)
5. Remove the screw that secures the lower
headlamp.
Remove Screw
6. Pull the headlamp out of the locking tab.
LOW BEAM HEADLIGHT
ADJUSTMENT
1. The low beam can be adjusted slightly upward or
downward.
Loosen Screw
2. Loosenthe phillips screw located at the rear of the
headlamp.
3. Tilt the headlamp upward or downward.
4. Tighten the screw.
HEADLAMP SWITCH TEST
1. Remove the headlight pod cover.
2. Set meter to DC Volts and probe the headlamp
plug wires (Brown and Yellow) at back of
connector for 12 Volts.
3. Turn ignition and headlight on. If there is no
power, continue with checks to the harness and
fuses.
Upper Headlamp Plug Wires
Brown
Yellow
Brown
Green
WORKLIGHT SWITCH
Remove the headlight pod cover to locate the switch
wires. The switch snaps out by pushing in on the tabs
on both sides of the switch.
Squeeze Tabs -- Push Thru to Remove
If the rear work lights will not come on, check the
following: