Filter
Top Products
8-18
Garmin GTN 625/635/650 Pilot’s Guide
190-01004-03 Rev. B
Foreword
Getting
Started
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Music
Utilities
System
Messages
Symbols
Appendix
Index
8.1.2.5 Traffic (Optional)
The Traffic group selection from the Map Setup Page Menu allows you to
customize the display of traffic on the Map page. The Traffic function requires
the installation of the appropriate traffic device. TIS and TAS cannot be displayed
at the same time. If the aircraft has a TAS unit installed, the GTN unit will be
configured for TAS. If no TAS unit is installed and a GTX Mode-S transponder is
installed, the GTN unit will be configured for TIS. Coverage is limited to specific
areas as shown in the AIM. TAS data comes from a TAS unit such as a Garmin
GTS 800 or 820, Skywatch 497, KTA 810, or other unit. Coverage follows the
airplane. In the Navigation Map page setup you can select the maximum range
at which traffic symbols are shown. Once outside of the selected range, traffic
will be decluttered. The default values are shown in bold type.
Traffic Selection Display Result
Range 1 NM, 1.5 NM, 2.5 NM, 4 NM, 5 NM, 7.5 NM, 10 NM,
15 NM, 25 NM
Traffic All Traffic, PA/TA, TA Only
Restore Defaults Returns values to original factory settings
Table 8-4 Map Page Traffic Display Options