Filter
Top Products
6-12
Garmin GTN 625/635/650 Pilot’s Guide
190-01004-03 Rev. B
Foreword
Getting
Started
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Music
Utilities
System
Messages
Symbols
Appendix
Index
6.8 Flying a DME Arc Approach
Approaches that contain DME arcs are supported by the GTN. The GTN will
provide guidance (left / right) relative to the arc. If you wish to activate the DME
arc leg manually, the aircraft must be near the arc, as shown in the shaded area
below.
Figure 6-19 DME Arc Example
6.9 Vectors to Final
With “Vectors-To-Final” (VTF) selected, the CDI needle remains off center
until you’re established on the final approach course. With the approach
activated, the Map Page displays an extension of the final approach course in
magenta (remember, magenta is used to depict the active leg of the flight plan)
and “vtf” appears as part of the active leg on the Map page (as a reminder that
the approach was activated with vectors-to-final).