Filter
Top Products
8-17
8.14 MESSAGES
You may recall from Section 2.6 that
some messages will remain on the
Message Page after being viewed.
When this occurs, the “MSG”
annunciator remains on (but does not
flash) in the lower left corner. To view
these messages, select “Messages”
from the Main Menu. (See Appendix A
for a description of available
messages.)
8.15 DENSITY ALTITUDE / TRUE AIRSPEED / WINDS ALOFT(E6-B)
The GPS 95 provides density altitude,
true airspeed (TAS) and winds aloft
calculators for your convenience. The
density altitude and TAS calculations
will help you determine critical aircraft
performance data.
The last field on the Beacon Receiver
Setup Page is the “View Beacon Log?”
confirmation field. Pressing ENT on
this field will display the Beacon Log
Page which lists the last five
frequencies you have attempted to
tune.
The most recently tuned frequency is at the top of the list. If the tuned
frequency, station identifier and position were available when the frequency
was last tuned, the list will also display the “Stn ID” number and the distance
to the transmitting beacon. You can tune any frequency on this list by
highlighting the desired frequency and pressing ENT. The display will
immediately return to the Beacon Receiver Setup Page with the selected
frequency from the Beacon Log Page as the “Tuned To:” frequency, and the
bit rate as the last bit rate used with the selected frequency. To return to the
Beacon Receiver Setup Page without selecting a frequency, press CLR.