Filter
Top Products
C-4
To connect to a remote alarm system...
· Connect the BLUE harness lead to the negative side of a transistor
alarm or relay switch.
· Connect the positive side of the alarm or relay to the positive side of
the 5 to 40 volt DC power source.
The GPS 95 may be connected to a PC-compatible computer using a NMEA
0183 data interface or to marine electronics such as an autopilot or plotter
which use an NMEA 0180, NMEA 0182 or NMEA 0183 data interface. The unit
can provide data for up to three NMEA “listeners” simultaneously. Refer to
installation instructions of these devices for further information.
To connect the GPS 95 to an NMEA electronic device...
· Connect the BROWN harness lead to the NMEA “A” line of a two-wire,
shielded cable.
· Connect the BLACK harness lead to the NMEA “B” line of the shielded
cable.
· Connect the BLACK harness lead to the shield of the shielded cable.
(The opposite end of the shield should not be grounded.)
C.3 YOKE MOUNT INSTALLATION
The GPS 95 is equipped with a yoke mount which can quickly be attached
to the control yoke for easy access and visibility without blocking the view of
the instrument panel. The yoke mount can be detached and stowed in the
carrying bag along with the GPS 95 and any other accessories you might
wish to take with you. The clamp that comes with the standard yoke mount
comes in a configuration that will fit the control yoke of more than 90% of
general aviation aircraft.
To attach the yoke mount to the control yoke...
· Loosen the lower knob.
· Slide the clamp over the control yoke shaft just behind the control
wheel.
· Tighten the lower knob securely.
· Make sure that the clamp is as close as possible to the control wheel
and check to make sure that the yoke travel is not limited or
hindered in any way by the yoke mount.