Filter
Top Products
C-6
To attach the yoke mount to the control yoke...
· Open the clamp jaw to its widest extent by unscrewing the lower knob.
· Slip the clamp over the horizontal member of the control yoke. Position
the clamp as far as possible toward the center column.
· Tighten the lower knob securely.
· Check to make sure the yoke travel is not limited or hindered in
any way by the yoke mount.
In some large diameter column mounting applications, the threaded portion
of the lower knob may extend an excessive distance from the yoke mount,
obscuring panel controls. In this case, use the provided lower knob with
shortened stud. It can be used interchangeably with the longer stud knob that
came installed in the clamp.