Filter
Top Products
8-13
The GPS 95 also features an alarm clock which can provide an alarm tone
and the message “Alarm Clock” at a time that you specify.
To set the alarm clock...
· Highlight the alarm clock time and enter the desired alarm time. NOTE:
The alarm time may be either UTC or local time depending on the
setting on the Date/Time Page. (See Section 8.17)
· Press ENT.
· The on/off cyclic field is highlighted. If the alarm is not turned on, press
CLR.
The graphic CDI may be configured to the desired scale and steering
orientation. Scale setting of ± 0.25, 1.25 or 5.00 units (nautical miles, statute
miles or kilometers) are available. The scale setting represents the distance
from the center of the CDI to either end.
To set the CDI scale...
· Highlight the CDI scale field.
· Press CLR to select the desired scale.
The CDI “Steer To” orientation determines how you interpret the “D-Bar”
when it moves. You may select a “Steer to >Center” or “Steer to >D-Bar”
orientation. A “Steer to Center” orientation, in effect, displays your position
as the D-Bar and the center of the CDI is the desired track. Thus, when you
are off course, you would steer towards the center of the scale. A “Steer to
D-Bar” orientation is just the opposite. The D-Bar represents the desired
track and the center of the scale represents your position. When you are off
course, you then steer towards the D-Bar. A “Steer to D-Bar” orientation is
the typical setting for aviation use and will make the GPS 95's graphic CDI
respond much like the CDI on your instrument panel.
To set the CDI orientation...
· Highlight the “steer to” field.
· Press CLR to select the desired orientation.