Filter
Top Products
A-2
controlled airspace.
Leg Not Smoothed- The upcoming leg is too short for smooth waypoint
transitions. Expect a rapid change in the CDI.
Memory Battery Low - The battery that sustains user memory is low and
should be replaced by an authorized GARMIN service center as soon as
possible. Failure to do so may result in loss of stored data, including all
waypoints and routes.
Need Altitude - The GPS 95 needs altitude to start and/or continue 2D
navigation. Press NAV and enter your current altitude. The altitude you enter
should be as accurate as possible. An inaccurate altitude will result in an
inaccurate position and navigation information.
No DGPS Position - An RTCM input has been selected, but insufficient
Differential GPS (DGPS) data is available to calculate a corrected position.
No RTCM Input - The RTCM device (such as a beacon receiver) is
improperly connected to the GPS 95, the RTCM device is not transmitting in
an RTCM SC-104 version 2.0 format, or the baud rates between the RTCM
device and the GPS 95 do not match.
Osc Needs Adjustment - The GPS 95 has detected excessive drift in its
internal crystal oscillator which may result in longer acquisition time. The unit
should be taken to an authorized GARMIN service center as soon as
possible.
Poor GPS Coverage - The GPS 95 cannot acquire sufficient satellites
necessary to provide navigation.
Pwr Down and Re-init - The GPS 95 is unable to compute a position due
to abnormal satellite conditions. Power down the unit and verify that the
position on the Position Page is within a few degrees of your actual position.
Received Invalid Wpt - A waypoint was received in an upload/transfer
operation that has an invalid identifier or position.
Receiver Failed - The GPS 95 has detected a failure in the receiver
hardware. If the message persists, the GPS 95 is unusable and should be
taken to an authorized GARMIN service center.
ROM Failed - The GPS 95 has detected a failure in its permanent memory.
If this message occurs, the unit is unusable and should be taken to an
authorized GARMIN service center.