Filter
Top Products
C-7
To substitute the lower knob with shortened stud...
· Peel back the protective rubber on the V-block.
· Use a 1.5mm hex wrench to remove the M1.7 hex head screw.
· Completely unscrew the lower knob.
· Screw in the alternate lower knob.
· Re-attach the V-block as shown.
NOTE: A shorter V-block is available for Beech models having a dual yoke
arrangement with a large rectangular cross-section. If the standard V-block/
clamp arrangement does not fit the cross-section, contact our Product
Support department to obtain the shorter V-block. (See Section C.9 for
Product Support information.)