Filter
Top Products
87
Service Manual
Third edition, June 1997
8.2 Checking the Tank Display Power Supply Unit
The Fl, F2 and F3 fuses (ratings 250 V/4 A) are located on a
separate fuse panel.
1. Loosen the four screws to remove the cover.
2. Check if the fuses are intact. Replace if necessary. Also,
reset the circuit breaker next to the transductor by
pressing the reset button between the side panel of the
unit and the interior vertical panel.
3. Replace the cover and tighten the bolts.
RESET
F 1
F 2
F 3
Figure 8-3. Checking the TDU Power Supply Unit.