Filter
Top Products
47
Service Manual
Third edition, June 1997
If not even LCS Simulation gives a “distance”, the reason for
fault is likely to be located on the LCS Board.
3.26 Level Unit – Scan Tank
The scan tank function is used when there is a need to view
the radar echoes inside the tank. This function is used during
the commissioning of the system. A Saab service engineer
will use this window to measure and save a curve of the
signal strength throughout the tank.
The function of the Scan Tank-window is not described in
this manual since it is not used during normal service of the
system. The results need to be evaluated by an experienced
Saab service engineer.
3.27 Level Unit – Restart LCI, LCM
Use this window to restart the LCI or the LCMs. Restarting
the LCI also causes both the LCM and the transmitters to
restart. Restarting the LCM also causes the transmitters to
restart.