Filter
Top Products
51
Service Manual
Third edition, June 1997
The value for digital inputs or outputs is shown as either 0 or
1. For digital outputs, it is possible to change the value and
hit the Save-button to see that the output is working. Some-
times detection of the output is easier if the Blink selection is
set to 1. The output (for example relay) will change back and
forth between active and inactive.
The value for analog inputs or outputs is shown in unscaled
units. The maximum and minimum values for the terminal
are shown and cannot be changed. These values could, for
example, be the unscaled raw values from a SIOX-system.
The check boxes show if the terminal has been set to be inac-
tive or if it has been given a high priority.
3.32 Install/Backup-Window
Use this window to make a backup copy of pictures and
database or to install new software. We recommend that you
make two backup copies of database and pictures every six
months. Store one copy in a safe place together with program
diskettes. Send one copy to Saab Marine Electronics for
storage on network servers. In this way the database and
pictures of your system will always be up to date. When
communicating with Saab Marine, this updated information
will be of great help when fault finding, changing pictures or
in any other way updating the system.
3.32.1 Backup Copies of the Database and Pictures
Follow the instructions below when making backup copies of
the database and pictures:
Note: When there is a network of Work Stations, backup must be
made from the Master Work Station.
1. Slide an empty DOS-formatted diskette into the dis-
kette drive.
2. Open the Install/Backup-window.
3. Hit the Backup-button. A menu is opened.