Filter
Top Products
18
Service Manual
Third edition, June 1997
3.5 Screen Settings of the Work Station Monitor
There are a number of controls below the monitor’s screen.
Whenever the picture on the screen looks distorted or incor-
rect, changing the screen settings may produce a better pic-
ture.
See maker’s manual (Hewlett-Packard) in the Saab TankRa-
dar G3 manual binder for information on the monitor con-
trols.
3.6 Loading Software to a Work Station
Follow the instructions below to install new software onto
the hard disk of the Work Station. This needs to be done, for
example, if the hard disk has been replaced.
The software consists of three parts: program, database and
pictures. This is complemented with your own backup copy
of database and pictures.
The program is stored on diskettes that are stored on board.
The first diskette is a boot-diskette which means that the PC
can be started on that diskette.
If any other diskette is in the drive when powered on, the
operator will be notified to remove it.
3.6.1 Install Program on Hard Disk of Work Station
1. Slide the Boot-diskette into the disk drive of the Work
Station.
2. Restart the Work Station by pressing the Reset button
on the front of the PC. The Work Station will now re-
start on the Boot-diskette in the disk drive.
3. Follow the instructions on the screen to install the new
program.
4. When the installation is finished the Work Station will
restart using the new program.
3.6.2 Install Database and Pictures on Hard Disk of
Work Station
Database and pictures are stored on a diskette. At the deliv-
ery of the TankRadar system, a diskette with files for data-
base and pictures is included. As you make changes to your
system you should make backup copies of your database and
pictures. See chapter 3.32.
Follow the instructions in chapter 3.32 to install database or
pictures onto the hard disk of the Work Station.