Filter
Top Products
85
Service Manual
Third edition, June 1997
7.2 Replacing a Faulty Temperature Sensor
To replace a faulty Pt 100 element, proceed as follows:
1. Remove the cover of the Temperature Connection Box.
2. Loosen the cap nut completely.
3. Loosen the adapter nipple using the box spanner from
the spare parts set.
4. Pull out the temperature sensor completely.
5. Insert a new temperature sensor completely. If it is not
entered completely the cover will not fit. Tighten the
adapter nipple first using the box spanner.
6. Make sure the conical metallic packing is correctly
fitted in the cap nut, and then tighten the cap nut se-
curely.
Cap nut
Metal
packing
Adapter
nipple
Figure 7-4.