Filter
Top Products
Set Up and Calibration Procedures
Drive Set Up Group
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual 57
7/08
Actuator Lower
Display
Prompt
Selections or
Range of Setting
Parameter Definition/PDA HercuLink
®
Prompt
LREP
mmddyy *
or
ddmmyy
DATE OF LAST REPAIR
— Factory set only. Displays date
of last repair.
LCAL
mmddyy *
or
ddmmyy
DATE OF LAST FACTORY CALIBRATION— Factory set
only. Displays date of last factory calibration
REPTYP
NONE
01
02
03
04
05
06
07
08
09
10
11
12
13
REPAIR TYPE
— Factory set only. Displays a repair code to
identify the type of repair service previously performed.
None
Future
Non-contact Sensor
Main CPU PWA repair
Motor service
Power Distribution PWA service
Switch repair
Relay service
Gear service
Service to repair water damage
Service to repair damage caused by heat
Service to repair due to over-voltage damage
Actuator reconfigured
Warranty Repair
* NOTE: Date format is set by the UNITS parameter. See SET DISPLA set up group.