Filter
Top Products
Set Up and Calibration Procedures
Digital Input Set Up Group
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual 51
7/08
Digital Input Set Up Group
Table 17 lists the parameters and selections availible for the SET DIGINP group.
Table 17 Digital Input Set Up Group Parameters
Actuator Lower
Display
Prompt
Selections or
Range of Setting
Parameter Definition/PDA HercuLink
®
Prompt
DIGINP
NONE
UP
DOWN
USER
default = UP
Digital Input State
— Selects the position of the actuator in
response to a digital input signal (contact closure).
None— No action by the actuator.
Up— Actuator motor moves to full scale value.
Down— Actuator motor moves to zero value.
User selected value— Actuator motor moves to a
customer-selected value.
* Allows setting of End Position Value.
EndPos
0 – 100
(in percent)
END POSITION VALUE
— (DIGINP USER only) Selects the
motor position you want the actuator to go to when digital
input signal present (contact closure).