Filter
Top Products
Set Up and Calibration Procedures
Set Up Tips
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual 33
7/08
Set Up Tips
Table 7 contains tips that will help you view, verify and enter the operating parameters more quickly. If
you cannot change the parameters, check the status of the “SET LOCK” parameter. Also some parameters
require that you enter a security password before you access or change the parameter value.
Table 7 Set Up Tips
Function Tip
Displaying Groups
Use the SET UP key to display and scroll through the set up groups. The
group titles are listed in the order that they appear on the actuator
display.
Displaying Functions
Use the FUNCTION key to display the individual function parameters
under each set up group. The prompts are listed in the order of their
appearance in each group. See Tables 8 through 19.
Scrolling
Pressing and holding the SET UP key will scroll through the set up
groups. However, when any set up group is displayed, you can scroll
through the set up groups twice as fast using the
or key. When in
any set up group, hold the FUNCTION key in to scroll through the
prompts within that group.
Changing values quickly
When changing the value of a parameter, you can adjust a more
significant digit in the upper display by holding in one key
or and
pressing the other
or at the same time.
• The adjustment will move one digit to the left.
• Press the key again and you will move one more digit to the left.
Exiting Set Up mode
To exit Set Up mode, press the DISPLAY key.
This returns the display to the same state it was in immediately preceding
entry into the Set Up mode.
Timing out from
Set Up mode
If you are in Set Up (configuration) mode and do not press any keys for
thirty seconds, the actuator display will time out and revert to the mode
and display that was being used prior to entry into Set Up mode.