Filter
Top Products
JKSSS+ Series - 70
JKSSS+ Series 2.3 - 4.2KV
6.1 MeteringPageList
The following charts list each Metering Page and the functions within that page. The
applicable section of the manual is also referenced.
6.1.1MeteringMenu&Data(MeteringPage1)
The soft starter offers performance metering which gives the user the ability to view
information about the motor and the JKSSS+ unit.
6.1.2Metering(MeteringPage2)
6.1.3RTDValues(MeteringPage3)
Metering
Page
Description of Display Screen
Phase A, B, C and Ground Fault (Option) 1
Average current of the % of imbalance and the motor's RPM 2
Motor load as a percentage of motor FLA 3
Line frequency and present phase sequence 4
Percentage of remaining Thermal Register 5
Thermal capacity required to start the motor 6
Average time required to start7
Average current during start8
Measured I
2
T required to start the motor
9
Amount of time required to start the motor during the last successful start10
Page 1
Metering Menu & Data
Metering
Page
Description of Display Screen
Phase A, B, C currents and Power Factor 1
Phase A, B, C currents and Ground Fault (Option) 2
Displays kW and kVA 3
Displays kVAR and Power Factor 4
Displays Peak ON and kW Demand 5
Displays Peak ON and kVA Demand 6
Displays Peak ON and kVAR Demand 7
Displays Peak ON and Amps Demand 8
Clears Demand values 9
Displays Megawatt hours used 10
Press enter to clear statistics on MWH values 11
Page 2
Metering
Metering
Page
Description of Display Screen
Hottest stator RTD (#1 - 6) 1
Hottest non-stator RTD (#7 - 12)
2
Temperature of start phase A1 in °C and °F 3
Maximum temperature for RTD #1 4
Same as Screens 3 - 4 for RTDs #2 - 12 5 - 26
Clear the maximum temperature register (Level 3 password required) 27
Measured running thermal stabilization time of motor (in minutes)
28
Measured stopped cooling time (to ambient) of motor (in minutes)
29
Page 3
RTD Values