Filter
Top Products
12.7
•
Loosen base plate (1) and turn to the left or right
until diode (2) on ignition setting device goes out.
L Note:
Ignition timing adjustment
Turn to left Retard ignition
Turn to right Advance ignition
•
Firmly tighten base plate.
•
Check ignition timing:
Crank engine in normal direction. The diode on
the ignition setting device must go out at piston
position 0.24 (0.00945 in) mm before TDC.
X Tightening torques:
Base plate................................................... 3.5 Nm
Cover ............................................................. 9 Nm
Spark plug.................................................... 20 Nm
12 3 650
LT120040
1
2